Beijing Plink AI Technology Co., Ltd
Beijing Plink AI is an expert of cloud-to-end one-stop solution.
Add to Cart
Industrial Jetson Xavier NX Module Nvidia Xavier Carrier Board 8G
PLINK Jetson Xavier NX developer kit Y-C6-DEV-NX
Y-C6-DEV-NX Jetson Xavier Nx Module is a Plink-AI development system powered by the Jetson Xavier NX module.Jetson Xavier NX is production-ready and supports all popular AI frameworks. This opens new possibilities for embedded edge-computing devices that demand increased performance to support AI workloads but are constrained by size, weight, power budget, or cost.
Jetson Xavier NX integrates a 128-bit wide LPDDR4x memory interface implemented as four 32-bit channels with x16 sub- partitions. The memory controller provides a single read or write command, plus a row address to both sub-partitions in the channel to transfer 64 bytes. It also provides three independent column address bits to each sub-partition, allowing it access different 32-byte sectors of a GOB between the sub-partitions. It provides connections between a wide variety of clients, supporting their bandwidth, latency, quality-of-service needs, and any special ordering requirements that are needed. The MSS supports a variety of security and safety features and address translation for clients that use virtual addresses.
Jetson Xavier Nx Module Features:
LPDDR4x: x32 DRAM chips
128-bit wide data bus
Low latency path and fast read/response path support for the CPU complex cluster
Support for low-power modes:
Software controllable entry/exit from self-refresh, power down, and deep power down o Hardware dynamic entry/exit from power down, self-refresh
Pads use DPD mode during idle periods
High-bandwidth interface to the integrated Volta GPU
Full-speed I/O coherence with bypass for Isochronous (ISO) traffic
System Memory-Management Unit (SMMU) for address translation based on the ARM SMMU-500
High-bandwidth PCIe ordered writes
AES-XTS encryption with 128-bit key
Jetson Xavier Nx Module Product parameters
Support native system
Anti falling off interface design
Power onself start
Size: 120mm*80mm*35mm
Adapter: AC to DC /220V to +12V 5A
Temperature: -25~+80°C
Support the officia lsystem without changing the kernel
| USB 3.1 Type-A | 1 |
| Micro USB | 1 |
| RS-232 | 2 |
| 3.3V GPO | 1 |
| 3.3V GPIO | 3 |
| micro SD | 1 |
| Nano SIM | 1 |
| MiniPCIe | 2 |
| 2 Lane MIPI | 2 |
| CAN | 1 |
| (10/100/1000BASE-T) RJ45 | 1 |
| 3.3V Debug(UART) | 1 |
| CR1220 RTC Battery | 1 |
| HDMI 2.0 | 1 |
| 3.3V SPI | 1 |
| 3.3V I2C | 2 |
| 30-pin2.0mm Multifunctional interface design | 1 |